Application Procedure Part 3

Application Procedure for SALT RESISTANCE PRIMER

Existing Salt Efflorescence Problem- Old Construction

To overcome the SALT problem steps involved in the treatment are-

1.      Clean the surface (surface has to be free from Salt, loose dust, oil Paints, grease & algae.) Clean the surface using Wire brush/ Nylon Brush/Scrapper/ metal plate to chip of the tough paint peel & Water. Special care has to be taken for scrapping of the salt.

2.      Apply uniform layer of Mx Seal Prime-50 Solution 2 Coat with brush on the effected scrubbed substrate. (Apply the 2 coats with in interval 1 Hr) Leave it for 1 or 2 Days.

3.      If again Salt Precipitate are Seen, Then again scrap the salt and apply 1 Coat of Mx Seal Prime-50 and 2 coat of Mx Seal Prime ’P’ and leave it for a day.

4.      After the salt is being treated apply Water /Acrylic base Paints.

 

                                                             After Coating

         Before Coating  

New Construction

  
 1.      Repeat Step 1 & 2.

 2.      Apply 2 coat of Mx Seal Prime 50 in area of normal salt content

 3.      Apply 2 coat of Mx Seal Prime 50 + 1 coat of Mx Seal Prime 

 

Application Procedure on Wall Area:-

To overcome HEAT problem steps involved in the treatment are-

1.   Clean Wall surface (surface has to be free from

 loose dust, oil, grease, bitumen & algae.) Clean 

the surface using Wire brush/ Nylon Brush/Scrapper & Water.

2.   Wash the surface thoroughly with water 

using pressure pumps.

3.   Apply uniform layer of one coat Mx SealPrime 

Solution with brush/ Roller on substrate.

4.   After duration of drying of 3-4 hrs apply 2 coats of Mx COOL WRAP
Plus with brush/ Roller/ spray. ( at interval on 3-4 hrs)

5.   For full curing let the coating dry for 12 hrs.